PZU-6-10kV-U-2-NG

The device is used on overhead power lines with a voltage of 6–20 kV and is installed on pin insulators with side wire binding on anchor-angle power line support towers.
The device is prefabricated, all elements are reliably and quickly assembled into a single product. It is mounted on overhead power line wires by means of the inner fastening clamps ZMI-2.

It is used on insulators of the following types ShF-10, ShF-20, ShS-10, ShS-20, ShTIZ-10V, ShTIZ-20V, ShP-10, LShP-10, ShP-20, LShP-20 and their modifications and analogues.

Product features

Voltage class of overhead lines: 6–20 kV

Overall dimensions of the device (mm):
1890 x 155 x 141

Windy area, icy area: I–VII

Climatic version execution:
(NF) - moderately cold climate.

Weight +/- 10% (kg): 0.75

Kit composition:
Hood – 2 pcs.;
Corrugated sleeve – 2 pcs.;
Connector – 1 pc.;
Fastening means (latch) – 6 pcs.;
Tie clamp – 2 pcs.;
Operation manual – 1 pc. per batch.

Installation time (min): up to 2

PZU-6-10kV-U-2-NG

Advantages PZU-6-10kV-U-2-NG

Protects the wire between two insulators even in the case of an increased distance, which significantly increases the efficiency of the device compared to analogues.

The one-piece cast hood ensures the reliability of the structure – eliminates deformation and “falling apart” of the PZU.

The flexibility of the corrugated sleeves allows the device to be installed on both straight and turning sections.

The transportation costs are significantly reduced due to the small size of the disassembled device.

Fasteners (ZMI-2 clips) are installed inside the corrugated hose, what speeds up installation of the device.

Pre-assembled packaging, quick installation, lightweight and compact size.

Review and installation of PZU-6-10kV-U-2-NG